The air suspension control unit is designed to facilitate the installation of the electrical part of the air suspension control, and remote, manual, control of the pneumatic system. The air suspension control unit combines. Relay unit (1 mechanical and 10 electronic). Emergency control unit for valves and compressor. 10 buttons allow you to control both individually and simultaneously with valves and compressor. Samo diagnosis, the presence of a connection (contact). 10 LEDs are able not only to indicate whether voltage is supplied to the valve and compressor, but also indicate the presence of the connection itself. The LED will not light until a consumer is connected (compressor or valve). Unloading valve timer controller. This is a separate circuit responsible for the discharge of air from the line between the compressor and the non-return valve. The air suspension control unit is a complete product and does not require the installation of additional relays or fuses! The air suspension control unit has 11 “Relays”. 1pc – electromagnetic 40A, responsible for the inclusion of the entire control unit of the air suspension, when turning the ignition key. 9pcs – electronic (mosfet 40A field effect transistors), for switching valves. 1pc – mosfet 160A, to turn on the compressor! Thanks to the use of mosfet field effect transistors, it was possible to. To obtain a multiple margin of switched currents (for valves the margin is 20-30 times, for the compressor 8-16). Eliminate the possibility of contact burning, increase the number of on-off cycles almost to infinity! Mosfet performance is several times faster, faster than. In the block you just need to get the plus and ground from the battery, and connect the wires from the valve block and compressor, no additional relays or fuses… An instruction with marking the terminals and a detailed description is attached, the installation time of the electrical part of the pneumatic control, even for a person not experienced in electrics, will be no more than half an hour, for a pro 5 minutes!! For remote control of valves and compressor, the air suspension control unit is equipped with a wired remote control (RC). Depending on the number of function buttons, the remote control provides the ability to control the valves and compressor both individually and simultaneously. At the moment, there is a wired control panel with 13 function keys, and a 14 button to lock the remote control from accidental clicks. The remote control has a constant backlighting of the keys, and an additional status indicator (locked-unlocked). 12 keys is a pump-descent of each pillow separately, and each axis separately, the 13th button – inclusion of the compressor separately, for pumping of wheels. 3 fuses: – common for 40A, compressor 30A, and for all valves 10A. The controller-timer of the discharge valve is a microcircuit that opens the valve, for a few seconds, after the compressor is turned off. Unloading valve can be any NC solenoid valve 12V. All mosfets are additionally protected from avalanche breakdown Avalanche breakdown occurs due to the presence of inductance. For example, a solenoid or motor experiences a similar voltage surge when opening a key with an unlocked load. The item “Air suspension control unit. Remote Control. Compressor control. Switch Box” is in sale since Tuesday, October 1, 2019. This item is in the category “eBay Motors\Parts & Accessories\Car & Truck Parts\Suspension & Steering\Lower Kits & Parts”. The seller is “kochetkov_yuri” and is located in Zhigulevsk. This item can be shipped worldwide.
- Country/Region of Manufacture: Russian Federation
- Manufacturer Part Number: Does Not Apply
- Included Hardware: Mounting Hardware
- Brand: Maximus AIR